You are now ready to install the Steering Servo and the Steering Bar. You will need the components shown below:

To begin this step, we will first add the Steering Servo. Turn the car so that the Camera Module is facing away from you. Now add the servo so that the wire of the servo is towards the left. Attach the servo by using two M2x4 screws.

Next, find the 1-Arm Rocker Arm and a M1.5x4 screw to prepare for the steering bar assembly process.

Now, sandwich the Steering Bar (A7 Plate) between the Rocker Arm and the screw. Make sure you stick the screw through the very first hole in the Rocker Arm (you’ll be threading the plastic of the Rocker Arm while doing this.).

Ensure that the screw is a little bit loose so that the assembly can rock back and forth. You can do this by backing the screw out a ¼ turn once you’ve inserted it.

After plugging the Steering Servo into the D11 pins you can add the Steering Bar Assembly to the bottom of the Steering Servo using a Servo Screw (located in the Rocker Arm bag) as shown below.